Choosing a PCA Drag Index™

Every compute:analyze call needs a model with the arrow's PCA Drag Index™ (dragIndex). The OpenAPI document has its bounds. A lower value is sleeker; 100 is a typical hunting arrow with a field point.

Where a value comes from

Connect doesn't return a PCA Drag Index. Your app gets one of three ways:

  • Ask your user for their PCA Drag Index™. A value they enter may be shown back to them as entered. Our own apps don't show a user their value today, so most users won't know one: ask them to enter it only if they have it, and offer the table otherwise.
  • Fill in the build from PCA's published table, below. A value from it may be shown as "PCA Drag Index™" without the "estimated by YourApp" label.
  • Show your own estimate, labeled as yours, for a build the table doesn't cover: "PCA Drag Index™ (estimated by YourApp)". Never derive an estimate by systematically querying the API.

A value the user enters, or one resolved from their own sight-in, is better than the table. Prefer it when you have it.

PCA's published estimates

PCA Drag Index™ estimates for typical 3-fletch hunting arrows, 27–29 in

ShaftVanesField pointMechanical / hybridFixed, cut ≤ 1⅛ inFixed, cut > 1⅛ in
Micro (3–4 mm)Low profile8299104114
Micro (3–4 mm)Standard / high profile89106112122
Small (5 mm)Low profile91110116126
Small (5 mm)Standard / high profile99119125134
Standard (6–6.5 mm)Low profile93112120128
Standard (6–6.5 mm)Standard / high profile100120127135

4-fletch: add 5.

Map a build to one row and one column:

  • Shaft, by the manufacturer's outside diameter: micro is 0.255 in or less; small is over 0.255 to 0.285 in; standard is over 0.285 to 0.320 in. Above 0.320 in (aluminium, indoor, traditional) isn't covered.
  • Vanes, by the manufacturer's maximum height: low profile is under 0.42 in; standard / high profile is 0.42 in or more. Feathers aren't covered.
  • Point: field point means any field, bullet or target point, not a practice broadhead. Mechanical / hybrid means the blades are closed in flight, including hybrids with fixed bleeders. Fixed: split on the published cut diameter at 1⅛ in (1.125 in). If the cut is unknown, use the "≤ 1⅛ in" column.
  • Don't adjust for arrow length (27–29 in), point weight, arrow weight, or offset or helical up to 4°.

Use the table to fill in a user's build, and don't republish it or publish your own table of values (Developer Agreement). Brand and Attribution covers how to name and label the value.